Used to extract and install the trailing arm bush at the front of the rear suspension.

Designed for use on car, this tool is a big time saver.

Extraction:
Refer to fig.5 - Assemble components a shown. As force bolt 1-3 is turned with a wrench or socket and ratchet; double-check the alignment of the tools as the load is applied.
 
Installation: Refer to fig.6 - Fit new bush into No.5 sleeve. Slot design of No.4 should align to raised point to mark. It will perfectly complete while turning 1-3 force bolt to tighten up.

NOTE: This tool will insert the bush to the correct depth, But before installing the new bush, refer to the vehicle manufacturer s service instructions, or a proper manual, to establish the correct horizontal alignment positioning of the bush in the trailing arm.

Models: Mazda 3 (BK/BL) / Ford Focus (LS/LT) / Volvo S40 (Series 2)